Home > Multimedia > Video > Tutorials

DRAINAGE HOLES FOR TUBES AND PARTS

Consequences if drainage holes of tubes and parts are too small ?

GALVA UNION's tutorials

Tuto 1
Tuto 2
Tuto 3
Tuto 4
Tuto 5

Do not hesitate to contact your usual contact directly to find out more

Tutorial 4: Problems and Solutions for Holes of Small Size Tubes and Hollow Parts

In this case, the immersion time of the parts can be increased so that the zinc circulates correctly everywhere. This can cause deformations.

If the size of the holes is insufficient, the zinc flows too slowly through the holes and generates sagging.

So how ?

To ensure good galvanization, the drilling diameters must have a minimum dimension according to the profiles:

– Round: Example for a tube of 8 cm it is necessary to provide 2 holes of 20 mm each.
– Square: For a tube of 8 * 8cm it is necessary to provide 4 holes of 20 mm each.
– Rectangular: For a tube of 8 * 4 cm it is necessary to provide 2 holes of 20 mm each.

Holes should be drilled as close as possible to angles and welds.

The right size, the right place for drilling is the right solution.

So, it’s up to you!
Consult the Guide of Good Practices and for personalized advice contact the GALVA UNION group’s website closest to you.

 

GALVA UNION

 

GALVA UNION is the specialist of galvanization, powder coating and duplex treatment.

Privacy Preference Center

Données nécessaires

Les cookies d'analyse des visites permet à GALVA UNION de connaitre le nombre de visiteurs mensuels sur son site.

Google Analytics

Advertising

Analytics

Other